📚
SLG-20 Retractable Landing Gear Manual
  • Home
  • Safety Notice
  • Operation
    • Operation Overview
    • Control States
    • Input Signal Requirements
    • Parameter System
    • Pre Flight Checks
    • Spring Tension & Replacement
    • Auto Calibration & Servo Insertion
  • Console Interface
    • Using the Console Interface
    • Accessing the Console Interface on Windows
    • Accessing the Console Interface on Mac
  • Firmware and Software
    • Firmware Update Procedure
    • Firmware Releases
    • Loader Releases
  • Installation
    • SLG-20-AX Quick Start Guide
    • SLG-20 Quick Start Guide
    • Mounting and Hole Patterns
    • Electrical
    • Assembling Legs
  • Reference
    • Known Issues
      • Roll Oscillations on New Alta X Model
    • Servo Types
    • Payload Clearance
Powered by GitBook
On this page

Was this helpful?

  1. Reference

Payload Clearance

PreviousServo Types

Last updated 10 months ago

Was this helpful?

The SLG-20-AX Setup is designed to fit the Movi Pro and DJI Ronin 2.

In the past, we offered legs in two lengths. 600mm to suit Movi Pro and 700mm to suit Ronin 2

At the time this is written (Jul 2024) we have standardised on 650mm legs. To ensure clearance on the Ronin 2, we recommend use of our shorter Ronin 2 Compatible standoff.

To evaluate whether a custom payload will fit under the drone when using the SLG-20-AX legs on the Alta X, please refer to the drawing below.

363KB
XM2 SLG20 Retracts 650mm Tubes Payload Volume.pdf
pdf