📚
SLG-20 Retractable Landing Gear Manual
  • Home
  • Safety Notice
  • Operation
    • Operation Overview
    • Control States
    • Input Signal Requirements
    • Parameter System
    • Pre Flight Checks
    • Spring Tension & Replacement
    • Auto Calibration & Servo Insertion
  • Console Interface
    • Using the Console Interface
    • Accessing the Console Interface on Windows
    • Accessing the Console Interface on Mac
  • Firmware and Software
    • Firmware Update Procedure
    • Firmware Releases
    • Loader Releases
  • Installation
    • SLG-20-AX Quick Start Guide
    • SLG-20 Quick Start Guide
    • Mounting and Hole Patterns
    • Electrical
    • Assembling Legs
  • Reference
    • Known Issues
      • Roll Oscillations on New Alta X Model
    • Servo Types
    • Payload Clearance
Powered by GitBook
On this page
  • Module Mounting
  • SLG-20 Leg Kit
  • Using Custom legs

Was this helpful?

  1. Installation

Mounting and Hole Patterns

SLG-20 Mounting and Hole Patterns

PreviousSLG-20 Quick Start GuideNextElectrical

Last updated 3 years ago

Was this helpful?

Module Mounting

The dimensions and instructions for mounting the SLG-20 to your aircraft are provided below.

If you are retrofitting the SLG-20's onto a drone which previously used DJI M600/S800 retractable landing gear, make sure you have purchased our SLG-20 DJI Adapter plate which will allow you to use the same hole pattern for mounting. Refer to the DJI Adapter Plate Drawing below.

If you are integrating the SLG-20 Retractable Landing Gear into a custom drone, we recommend you use the mounting pattern on the top of the SLG-20 modules, refer to the SLG-20 Drawing below.

If you are using the SLG-20 on an Alta X, please purchase the SLG-20-AX Retract Kit for Alta X. The SLG-20-AX includes the SLG-20 modules pre-mounted onto an AX-plate and designed to bolt directly onto the

SLG-20 Leg Kit

The SLG-20 Leg Kit is a four leg kit with a horizontal crossbar at the bottom. The Leg Kit includes:

  • 6x 600mm 25mm Carbon Tubes

  • 4x Rubber End Caps

  • 4x Spring Holders

  • 4x T-Joints for 25mm Carbon Tube

The weight of the assembled leg kit is TODO Fill this in.

Using Custom legs

Alta X.
101KB
SLG-20 Mount Pattern.pdf
pdf
66KB
SLG-20 DJI Adapter Plate Dimensions.pdf
pdf
DJI Adapter Plate Drawing